WW2 Accessories

Home > Products > Outdoors Solutions > Wall Washers > WW2 Accessories

111 1/2' XLR to WW2 Conversion Cable

LCC-X3M/WW2-1
DMX Controller Cable
1 ½’ XLR to WW2 Conversion Cable

111 1/2' Hard Wire to WW2 Conversion Cable

LCC-HW/WW2-1
DMX Controller Cable
1 ½’ Hard Wire to WW2 Conversion Cable

11DMX 3-pin XLR Extension Cable - Plug & Play

LCC-XLR3-EXT-3
CC-XLR3-EXT-16
LCC-XLR3-EXT-32

DMX 3-pin XLR Extension Cable – Plug & Play

Length: 3′, 16′, 32′

111 1/2' Hard Wire to WW2 Conversion Cable

LCC-XLR3-EXT-3-HW
LCC-XLR3-EXT-16-HW
LCC-XLR3-EXT-32-HW

DMX 3-pin XLR Extension Cable – Hard Wire

Length: 3′, 16′, 32′

11Wall Washer Connecting Cable

WW2-CC-1
WW2-CC-6
WW2-CC-9
WW2-CC-16

Wall Washer Connecting Cable

Length: 1 ½’, 6 ½’, 9 ¾’, 16′

11LC-DMX-SPT DMX Splitter for Wall Washer series

LC-DMX-SPT-4
4-Port DMX Splitter, 120V AC
Required for runs over 180 feet or 30 fixtures to maintain DMX signal integrity. IP20
3 or 5 pin XLR input/output
Splits DMX signal into 4 outputs.

11LC-DMX-SPT DMX Splitter for Wall Washer series

LC-DMX-SPT-8
8-Port DMX Splitter, 120V AC
Required for runs over 180 feet or 30 fixtures to maintain DMX signal integrity. IP20
3 or 5 pin XLR input/output
Splits DMX signal into 8 outputs.

11DMX Signal Amplifier for Wall Washer series

WW2-DMX-AMP-1
DMX Signal Amplifier for WW2 Series
Required for runs over 180 feet or 30 fixtures to maintain DMX signal integrity. IP65
WW2 IP68 connector input/output
8″ L × 3 ½” W × 2 ½” H.

11DMX Connector End Caps Set

WW2-EC
DMX Connector End Caps Set
Set of IP68 DMX Connector End Caps (male and female)
to protect DMX connectors from water and dust.
Required for unused connectors in outdoor/wet environments.

11

DB-OD-HW-T
“T” Outdoor Distribution Block
Power an entire run with just one outlet.
Use one per fixture.
NEMA 6P rated.
Interconnected with 6.5-10mm SJTW-type cable (supplied by others).

11

DB-OD-HW-I
“I” Outdoor Connector
IP68 rated.