Home > Products > Outdoors Solutions > Wall Washers > WW5 Accessories
Glare Shield
WW5-HW-S12-GS
WW5-HW-S18-GS
WW2-HW-S24-GS
WW2-HW-S36-GS
WW2-HW-S48-GS
Glare Shield add-on to reduce glare
Length: 12″, 18″, 24″, 36″, 48″
Sold separately
Controller Cables
LCC-X3M/WW5-1
1 ½’ XLR 3-pin Connector (male) to
WW5 IP68 Connector (female) Conversion Cable
LCC-HW/WW5-1
1 ½’ Hard Wire to
WW5 IP68 Connector (female) Conversion Cable
DMX Cables – Plug & Play
LCC-XLR3-EXT-3
3′ DMX 3-pin XLR Extension Cable – Plug & Play
CC-XLR3-EXT-16
16′ DMX 3-pin XLR Extension Cable – Plug & Play
LCC-XLR3-EXT-32
32′ DMX 3-pin XLR Extension Cable – Plug & Play
DMX Cables – Hardwire
LCC-XLR3-EXT-3-HW
3′ DMX 3-pin XLR Extension Cable – Hard Wire
LCC-XLR3-EXT-16-HW
16′ DMX 3-pin XLR Extension Cable – Hard Wire
LCC-XLR3-EXT-32-HW
32′ DMX 3-pin XLR Extension Cable – Hard Wire
DMX Connecting Cables
WW5-CC-1
1 1/2′ Wall Washer Connecting Cable
WW5-CC-6
6 1/2′ Wall Washer Connecting Cable
WW5-CC-9
9 3/4′ Wall Washer Connecting Cable
WW5-CC-16
16′ Wall Washer Connecting Cable
Splitters
LC-DMX-SPT-4
4-Port DMX Splitter for Wall Washer series
3 or 5 pin XLR input/output.
Splits DMX signal into 4 outputs.
LC-DMX-SPT-8
8-Port DMX Splitter for Wall Washer series
Required for runs over 180 feet or 30 fixtures to maintain DMX signal integrity.
3 or 5 pin XLR input/output.
Splits DMX signal into 8 outputs. IP20.
End Cap
WW2-EC
DMX Connector End Caps Set
Set of IP68 DMX Connector End Caps (male and female)
to protect DMX connectors from water and dust.
Required for unused connectors in outdoor / wet environments.
Distribution Blocks
DB-OD-HW-T
“T” Outdoor Distribution Block
Power an entire run with just one outlet.
Use one per fixture.
NEMA 6P rated.
Interconnected with 6.5-10mm SJTW-type cable (supplied by others).
DB-OD-HW-I
“I” Outdoor Connector
IP68 rated.